Professional Service at Great Prices                FREE TESTING              Free ground shipping on outgoing shipments to 48 contiguous states excluding international            No restocking fees on returns within 10 business days 
Midwest ECM Repair offers remanufactured Cummins Celect and Cummins Celect Plus ECMs at great low prices.  We stand behind our work and are determined to offer you the most professional ECM repair service that you can count on. So choose Midwest ECM Repair for all your remanufactured Cummins ECMs—you'll be glad you did.

Cummins Celect ECMs P/N 3084473, 3618046, & 3619037

$1195.00  (with exchange of a rebuildable core)

Includes calibration to your CPL #

Includes programming to your Features and Parameters

One year unlimited mileage warranty. Warranty does not cover damage to ecm from external malfunctions (I.E. backwards batteries, welding while connected, shorted injectors, bad wiring harness, etc.) Warranty does not cover labor, towing or damage resulting from ECM failure. Warranty / liability shall be limited to the cost of the ECM.

A refundable core deposit of $400 will be charged, then refunded when we receive your rebuildable core.  (A rebuildable core is basically any Celect or Celect Plus ECM that does not have a burnt spot, short, or excessive corrosion on the circuit boards).  A non-rebuildable core will be refunded $100.

       OR

We can re-build your ECM for $995.00 in two days time.  It will also have a full one year warranty.

 Cummins Celect Plus ECMs P/N 3090528, 3096662, 3408300, & 3408303

$1195.00  (with exchange of a rebuildable core)

Includes calibration to your CPL#

Includes programming to your Features and Parameters

One year unlimited mileage warranty. Warranty does not cover damage to ecm from external malfunctions (I.E. backwards batteries, welding while connected, shorted injectors, bad wiring harness, etc.)

$400 core deposit

               OR

We can re-build your ECM for $995.00 in two days time.  It will also have a full one year warranty.

Also available

Used ECM Cooling Plates P/N 3062625 and 3062626     $100.00

Used ECM Harness Ends Celect & Celect Plus Sensor, OEM, and Actuator Harnesses, and Harness Retention Screws

The plugs, being cut from wrecked trucks, usually have 6 to 8 inches of wire from the connector.    $49.00 each for plugs

                                                                                                                                     2/$5 harness screws

Unused International ECM/ECU  Removed from new engines due to a change in the specified engine at the factory. May fit VT365, VT275, DT466E, and DT570 engines, check for interchangeability.  Part #s 1839368C2 and 1845496C95 for a 6.0 Liter     $400 Each

Minimum required info. for Calibration

CUMMINS

CPL#

Rear end Ratio

Trans.  model # (if over 430 h.p.)

Tire size or Revs/Mile

Make us aware if your truck has an automatic or auto-shift transmission

Road speed governor (if desired).

P.T.O. speeds desired

Idle shut-down (if desired).

On Celect Plus engines; let us know if you have a manual fan over/ride switch, factory or after market.